PCAN-LWL

Optical Coupler for CAN and CAN FD Data Transmission

For use in explosion-proof areas or for EMC measurements, the PCAN-LWL can be used to replace a stretch of CAN network with a fiber-optic line at any point. There are the options of conversion to High-speed CAN or Low-speed CAN. The modules are supplied with power externally.

The PCAN-LWL can be used in CAN FD busses with data bit rates up to 5 Mbit/s and nominal bit rates up to 500 kbit/s.

• LED display for transceiver status
• High-speed CAN: AMIS 30660 transceiver, max. 500 kbit/s, switchable 120-Ohm bus termination
• Low-speed CAN: TJA1055 transceiver, max. 125 kbit/s, switchable 510-Ohm / 5.6-kOhm bus termination, bus error display
• Complies with CAN specifications 2.0 A/B
• Suitable for the use in CAN FD busses with data bit rates up to 5 Mbit/s and nominal bit rates up to 500 kbit/s
• The fiber-optic line consists of a 62.5/125 µm fibre-optic duplex line with ST connectors
• Aluminum casing
• CAN bus connection via D-Sub, 9-pin (in accordance with CiA^® 303-1)
• Supply voltage: 6.5 – 30 V
• Supply via D-Sub 9-pin or DC connector (jumper)
• Operating temperature range from 0 to 70 °C 
  (32 to 158 °F)

• Pin assignment D-Sub

  

  Pin	Pin assignment
  1	Not connected
  2	CAN-L
  3	GND
  4	Not connected
  5	Not connected
  6	GND
  7	CAN-H
  8	Not connected
  9	VIN (optional)

   

  Scope of Supply

  • 2 CAN to optical waveguide converters including power supply units. Delivered in shockproof plastic box
  • A choice of 5 or 10 m FO cable, 62.5 / 125 µm duplex line ST connector. Other lengths available on request
  • Manual in PDF format
    
    

  Also available with Single-wire CAN transceiver on request.

   

   

  제조사 : PEAK-System Technik GmbH (독일)

   

  납기 : 약 5 ~ 10 일

   

  AS 방침 : 구입 후 1년간 무상 (단, 사용자 과실의 경우 실비 청구), 1년 후 유상 

• 
  

•